Roland TrueVIS VG2-540 - Setting the Temperature During Preheating

Seng the Temperature during Preheang
Preheang: State in which the main power and the sub power are switched on and [SETUP] is not lit (state in
which the media setup is not completed).
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
HEATER MENU
3. Press [▶], then [▼] to display the screen shown below.
HEATER MENU
PREHEATING
4. Press [▶] to display the screen shown below.
PREHEATING
30゜C 30゜C
5. Press [▲] or [▼] to select a seng.
• MENU: The system performs heang to the set temperature at all mes, without lowering the tempera-
ture during preheang.
• 30°C: The system maintains a temperature of 30°C (86°F) during preheang.
• OFF: The system switches the media heang system o during preheang.
6. Press [ENTER] to conrm your entry.
7. Press [MENU] to go back to the original screen.
MEMO
• Default seng: 30°C
Adjusting the Ink-drying Method
156 1. Optimizing the Output Quality