Roland TrueVIS VG2-540 - Step 3: Preparations for Cutting Output

Step 3: Preparaons for Cung Output
1. Switching O the Print Heater and Dryer
Procedure
1. Press [FUNCTION].
2. Press [▼] several mes to display the screen shown below.
FUNCTION
HEATER CONFIG
3. Press [▶] to display the screen shown below.
HEATER CONFIG
POWER ON
4. Press [▶].
5. Press [▲] or [▼] to select "OFF."
HEATER CONFIG
ON OFF
6. Press [ENTER] to conrm your entry.
The sengs for the print heater and dryer are turned o.
7. Press [FUNCTION] to go back to the original screen.
Cutting with Crop Marks
132 4. How to Cut with Crop Marks