Roland TrueVIS VG2-540 - Correcting the Misalignment of Printing and Cutting with Crop Marks (Separate Test for Printing;Cutting with Crop Marks); Correcting the Misalignment of Printing and Cutting with Crop Marks; Ing;Cutting with Crop Marks)

Correcng the Misalignment of Prinng and Cung with Crop Marks (Separate Test for
Prinng/Cung with Crop Marks)
Due to changes in the thickness of media caused by laminang and misalignment of the loading posion of the
media before and aer cung, the posioning of prinng and cung may be misaligned even when you are using
crop marks. Make correcons for misaligned prinng and cung for the media you are using and its condion.
In this test, so as to create the same condions as the actual operaon, print only the crop marks, remove the
media, load the media again, and then cut the media.
1. Adjust the misalignment of the ink landing posion.
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
MEDIA GAP ADJ.
3. Press [▲] or [▶] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
4. Press [ENTER].
Prinng of the test paern starts.
5. When prinng is nished, press [▼], then [▶] to display the screen shown below.
6. View the printed test paern, and then determine the correcon value.
Select the value that gives the least misalignment between the two lines. In the case of the following gure,
select "-3." When you cannot choose between two sequenal numbers, select a value that is between them
(you can set correcon values in units of "0.5").
7. Press [▲] or [▼] to select the correcon value.
8. Press [ENTER] to conrm your entry.
9. Press [◀] or [▲] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
10. Press [ENTER].
Prinng of the test paern starts.
11. Check the test paern to see whether the correcon was successful.
Check that the misalignment is minimized for the two vercal lines indicated by " " (that is, the current
correcon value). If the misalignment is smaller for another set of vercal lines, set the correcon value
again.
12. When you have successfully performed the correcon, press [MENU] to go back to the original screen.
Accurately Adjusting the Settings for Cutting with Crop Marks
1. Optimizing the Output Quality 179