Roland TrueVIS VG2-540 - Page 179

10. Press [▶].
11. Set the correcon values for the feed direcon "F" and the scan direcon "S."
(1) Press [▲] or [▼] to set the correcon value for the feed direcon (F).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(2) Press [◀] or [▶] to set the correcon value for the scan direcon (S).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(3) When you have nished seng the correcon values, press [ENTER].
12. Press [MENU], then [▲] to display the screen shown below.
CROP-CUT ADJ.
TEST PRINT
13. Press [ENTER].
The test paern (C&C1) is printed and cut. If the prinng and cung lines are aligned, adjustment is com-
plete. If further adjustment is needed, press [▼], then [▶] to go back to step 11 and ne-tune the adjust-
ment.
MEMO
• Default sengs
• F (correcon value of the media feed direcon): 0.00 mm
• S (correcon value of the cung carriage movement direcon): 0.00 mm
• Depending on the changes in the condion of media caused by laminang and the loading posion of the media before
cung, the posioning of cung may be misaligned. In such cases, refer to the following page.
RELATED LINKS
・ P. 179 "Correcng the Misalignment of Prinng and Cung with Crop Marks (Separate Test for Prinng/Cung with Crop
Marks)"
Accurately Adjusting the Settings for Cutting with Crop Marks
178 1. Optimizing the Output Quality