Roland TrueVIS VG2-540 - Step 2: Starting Output

Step 2: Starng Output
CAUTION
Never touch the print-head carriage while output is in progress.
The print-head carriage moves at high speed. Coming into contact with the moving carriage may cause
injury.
Procedure
1. In the case of output for the rst me on that day, shake the white ink pouch tray.
Remove just the pouch tray for the white ink, shake the pouch tray 50 mes (about 20 seconds), and then
reinsert this pouch tray. The precipitaon of the ingredients in the ink disables prinng in normal color. So
that the ink mixes well, shake the pouch tray horizontally with a stroke length of around 5 cm (2 in.) from
each end of the tray.
IMPORTANT
• The pouch trays for colors other than white do not need to be shaken before every operaon, but be sure to shake them
when installing new ones.
• Do not remove the ink pouches. Shake the enre pouch tray. Removing the ink pouches may lead to the ink leaking.
• Before shaking, wipe o any ink from around the mouth of the ink pouch. If you do not wipe o the ink, it may splaer
when you shake the pouch tray.
• When you have nished mixing the ink, reinsert the pouch tray immediately. Taking me to reaach the ink cartridge will
adversely aect the ink path.
• Even if you rarely use white ink, shake the pouch tray for the white ink 50 mes (about 20 seconds) once a week.
2. Close the front cover.
3. Check that [SETUP] is lit.
If [SETUP] is not lit, the setup is not completed. Lower the loading lever, and then press the [ENTER] key.
4. Wait unl [HEATER] stops ashing and stays lit.
5. Check that the screen shown below (the top menu) is displayed.
If the top menu is not displayed, press [MENU].
W1100mm
6. Send the output data from the computer.
For informaon on how to create the output data, refer to the documentaon for the included soware RIP.
Printing Output
74 1. Printing Method