Roland TrueVIS VG2-540 - Thoroughly Using the Middle Pinch Rollers

To Next Page

To Previous Page

Thoroughly Using the Middle Pinch Rollers

This menu lets you enable the checking funcon to make sure the operators who perform output will use the mid-

dle pinch rollers.

When this is set to "ENABLE", the message "SOME MID.PINCHS NOT SET RIGHT" is displayed if the user forgets to

place the middle pinch rollers during setup. Press [ENTER] to clear the message and complete the setup. Failing to

use the middle pinch rollers will cause the media feeding accuracy to drop and the media to come loose, which

will lead to a decrease in the output quality. If the message is displayed, we recommend that you raise the loading

lever and perform the setup of media again.

Procedure

1. Press [MENU].

2. Press [▼] several mes to display the screen shown below.

SUB MENU

3. Press [▶] once, and then press [▼] several mes to display the screen shown below.

SUB MENU

M.PINCH CHECK

4. Press [▶].

5. Press [▲] or [▼] to select "ENABLE".

M.PINCH CHECK

DISABLE ENABLE

6. Press [ENTER] to conrm your entry.

7. Press [MENU] to go back to the original screen.

MEMO

• Default seng: "ENABLE"

Managing the Operations Appropriately and Efficiently

210 3. Optimizing Operation Management

Other manuals for Roland TrueVIS VG2-540