Roland TrueVIS VG2-540 - Using Sticky Media

Using Scky Media
This seng is used to peel o the media before starng prinng when using media that scks easily to the platen.
This seng is eecve to prevent media jams.
Note, however, that peeling o the media may cause unstable media feed. Leave this menu item set to "DISABLE"
unless you specically need to change it.
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
SUB MENU
3. Press [▶] once, and then press [▼] several mes to display the screen shown below.
SUB MENU
MEDIA RELEASE
4. Press [▶] to display the screen shown below.
MEDIA RELEASE
DISABLE DISABLE
5. Press [▲] or [▼] to select "ENABLE".
6. Press [ENTER] to conrm your entry.
7. Press [MENU] to go back to the original screen.
MEMO
• Default seng: "DISABLE"
Configuring Settings to Match the Properties of the Media
1. Optimizing the Output Quality 149