Roland TrueVIS VG2-540 - Media Wrinkles or Shrinks; Is the Media Loaded and Set up Straight and Securely; Was Loaded Media Allowed to Stand for some Time; Are the Media Clamps Attached

Is the media loaded and set up straight and securely?
Feeding is not smooth when the media is not straight or is tensioned unevenly on the le and right. Reload the
media.
RELATED LINKS
・ P. 30 "Setup of Roll Media"
・ P. 40 "Setup of Sheet Media"
Was loaded media allowed to stand for some me?
Media may shrink or wrinkle if it is heated for an extended me. When prinng ends, switch o the sub power
and remove the media.
Are the media clamps aached?
When you are performing prinng, be sure to aach the media clamps.
Was the media loaded while the print heater was hot?
Loading media aer the print heater has warmed up causes the temperature of the media to rise suddenly, which
may cause the media to shrink or wrinkle during prinng. Before loading media, switch o the sub power and
allow the platen to cool.
RELATED LINKS
・ P. 152 "Adjusng the Ink-drying Method"
Are the media heang system temperatures too high?
Set the temperatures to suitable values for the type of media.
RELATED LINKS
・ P. 152 "Adjusng the Ink-drying Method"
Is the temperature of the room too low?
The media heang system may not warm up suciently when the ambient temperature is less than 20°C (68°F).
Also, even when the media heang system reaches its set temperatures, adequate eecveness may not be appa-
rent if the media is thoroughly chilled. Before prinng, allow the media to come to room temperature.
Is the humidity of the room too high?
Use the machine in an environment with a humidity of 35 to 80%RH (no condensaon).
Is the media sagging? If sagging media is used, it may come out wrinkled.
Is the media sagging?
If sagging media is used, it may come out wrinkled.
Media Wrinkles or Shrinks
284 3. Media Feed Problems