Roland TrueVIS VG2-540 - Using Hard-To-Dry Media

Using Hard-to-Dry Media
This seng is used to extend the drying me when the ink dries poorly even if the dryer is used.
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
SUB MENU
3. Press [▶], then [▼] to display the screen shown below.
SUB MENU
SCAN INTERVAL
4. Press [▶] to display the screen shown below.
SCAN INTERVAL
OFF OFF
5. Press [▲] or [▼] to select a value.
Larger values cause the media to move more slowly, enabling you to extend the drying me accordingly.
6. Press [ENTER] to conrm your entry.
7. Press [MENU] to go back to the original screen.
MEMO
• Default seng: "OFF"
• Depending on the soware RIP you are using, you can also make this seng in the soware RIP. When you have made the
seng in the soware RIP, the printer's seng is ignored.
Configuring Settings to Match the Properties of the Media
1. Optimizing the Output Quality 147