Roland TrueVIS VG2-540 - About the Blade

The cung condions and the service life of the blade change according to the media and the operang environ-
ment, even when you're using idencal blades. The service life also diers according to the type of blade. A rough
guide is shown below.
Blade Media Blade force
Amount of blade oset
(amount of blade p cor-
recon)
Blade life (general
guide)
*1
ZEC-U1005 General Signage Vinyl 50 to 150 gf 0.25 mm (0.01 in.) 8,000 mm (26,246.7 .)
ZEC-U5025
General Signage Vinyl 30 to 100 gf 0.25 mm (0.01 in.) 4,000 mm (13,123.4 .)
Fluorescent Vinyl 120 to 200 gf 0.25 mm (0.01 in.) 4,000 mm (13,123.4 .)
Fluorescent Vinyl 100 to 200 gf 0.25 mm (0.01 in.) 4,000 mm (13,123.4 .)
*1 The values for "Blade life" are esmates for when an idencal type of media is used.
When uncut areas remain even when the blade force is increased to a value that is higher than the values shown
in this chart by 50 to 60 gf, replace the blade.
About the Blade
2. Main Specifications 317