Roland TrueVIS VG2-540 - Setting the Drying Time after Printing (When Only Printing)

Seng the Drying Time aer Prinng (When Only Prinng)
To dry the ink thoroughly, set the drying me aer the 1st page is printed. This seng applies to output data de-
signed only for prinng.
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
HEATER MENU
3. Press [▶] once, and then press [▼] several mes to display the screen shown below.
HEATER MENU
DRYING TIME
4. Press [▶] to display the screen shown below.
DRYING TIME
PRINT
5. Press [▶] to display the screen shown below.
PRINT
0min 0min
6. Press [▲] or [▼] to select the drying me.
7. Press [ENTER] to conrm your entry.
8. Press [MENU] to go back to the original screen.
MEMO
• Default seng: 0 min
• The next operaon is not started unl the set me elapses.
• During drying, [PAUSE] is lit. Press [PAUSE] while [PAUSE] is lit to nish the drying me and start the next operaon.
• Hold down [PAUSE] while [PAUSE] is lit to cancel the output.
• When the drying me has been set in the soware RIP, priority is given to the soware RIP's seng.
• This seng is ignored for output data designed for prinng and cung. To set the drying me aer prinng when prinng
and cung, see the following secon.
RELATED LINKS
・ P. 159 "Seng the Drying Time aer Prinng (When Prinng and Cung)"
Adjusting the Ink-drying Method
158 1. Optimizing the Output Quality