Roland TrueVIS VG2-540 - Turning the Power off

Turning the Power O
WARNING
When output is not being performed, remove any loaded media or switch o the sub
power.
The connued applicaon of heat at a single locaon may cause the release of toxic gases from the me-
dia or pose a re hazard.
Procedure
1. Switch o the sub power whenever prinng is nished.
Hold down the sub power switch for one second or longer.
2. Raise the loading lever and remove the media.
When not using the machine, raise the loading lever even if the sub power is on.
Power Supply Operations
2. Basic Operations 27