Roland TrueVIS VG2-540 - Preparations before Cutting Output; Step 1: Switching off the Print Heater and Dryer

Step 1: Switching O the Print Heater and Dryer
Procedure
1. Press [FUNCTION].
2. Press [▼] several mes to display the screen shown below.
FUNCTION
HEATER CONFIG
3. Press [▶] to display the screen shown below.
HEATER CONFIG
POWER ON
4. Press [▶].
5. Press [▲] or [▼] to select "OFF."
HEATER CONFIG
ON OFF
6. Press [ENTER] to conrm your entry.
The sengs for the print heater and dryer are turned o.
7. Press [FUNCTION] to go back to the original screen.
Preparations before Cutting Output
2. Cutting Method 77