Roland TrueVIS VG2-540 - Performing Distance Correction During Cutting

Performing Distance Correcon during Cung
This correcon is performed when you want to accurately align the lengths of cut lines when cung. This seng is
also applied during cung only, prinng and cung, or cung with crop marks.
The movement distance of the media changes subtly depending on the media's thickness. This means that the
length of a line when cut may dier from the length seng in the data.
Procedure
1. Press [MENU].
2. Press [▲] to display the screen shown below.
MENU
CUTTING MENU
3. Press [▶] once, and then press [▼] several mes to display the screen shown below.
CUTTING MENU
CALIBRATION
4. Press [▶] twice to display the screen shown below.
FEED SETTING
0.00% 0.00%
5. Press [▲] or [▼] to select the correcon value.
Set the correcon value of the media feed direcon.
FEED SETTING
0.00% -0.10%
6. Press [ENTER] to conrm your entry.
7. Press [◀], then [▼] to display the screen shown below.
CALIBRATION
SCAN SETTING
8. Press [▶] to display the screen shown below.
SCAN SETTING
0.00% 0.00%
9. Press [▲] or [▼] to select the correcon value.
Set the correcon value of the cung carriage movement direcon.
10. Press [ENTER] to conrm your entry.
11. Press [MENU] to go back to the original screen.
MEMO
• Default sengs
• FEED SETTING: 0.00%
• SCAN SETTING: 0.00%
Accurately Adjusting the Cutting Settings
166 1. Optimizing the Output Quality