Before moving the machine, dispose of the discharged uid and secure the print heads in place. Aempng to
move the machine without rst performing these preparaons may result in damage to internal components due
to leaking ink or damage to the print heads.
IMPORTANT
• Once the preparaons for moving the machine are complete, move the machine promptly and turn on the machine as soon as
possible aer the machine is relocated. If you leave the machine alone without turning it on, the precipitated ink will coagulate and
result in problems such as the clogging of the print heads.
• When moving the machine, keep it at a temperature from 5 to 40°C (41 to 104°F) and at a humidity from 20 to 80% (with no
condensaon). Failure to do so may result in a breakdown.
• Handle the machine with care when moving it, keeping it level (not lted at an angle) and prevenng it from striking other objects.
• Aer the printer is reinstalled, the media holder adjuster must be adjusted by a suitably qualied worker. This work must be per-
formed by a Roland DG worker. Contact your authorized Roland DG Corporaon dealer.
Step 1: Removing Media and the Blade Holder
Procedure
1. Remove any media.
If any media has been loaded, remove it.
If no media is loaded, raise the loading lever.
2. Press [MENU].
3. Press [▼] several mes to display the screen shown below.
4. Press [▶] once, and then press [▼] several mes to display the screen shown below.
5. Press [▶] once, and then press [▼] several mes to display the screen shown below.
6. Press [ENTER].
The cung carriage moves to a posion where blade replacement is possible.
7. When the following screen is displayed, open the front cover.
Preparaon is complete once the following screen is displayed.
Preparing to Move the Machine
306 1. Operations When Moving the Unit
To Next Page
Loading...
