Roland TrueVIS VG2-540 - Conditions for Usable Media

Condions for Usable Media
This machine cannot print on every kind of media. When selecng media, be sure to carry out tesng in advance
to make sure that sasfactory prinng results are obtained.
Size
64-inch model 54-inch model
Width
*1
315 to 1,625 mm
(12.4 to 64 in.)
275 to 1,371 mm
(10.8 to 54 in.)
Cuable media thickness
*1
0.08 to 0.22 mm (3.2 to 8.6 mil; depends on the material of the media)
Maximum media thickness (including backing
paper)
*1
When performing prinng only: 1.0 mm
When performing cung: 0.4 mm (15 mil)
Maximum roll outer diameter 210 mm (8.2 in.)
Paper tube (core) inner diameter
76.2 mm (3 in.) or 50.8 mm (2 in.)
*2
*1 Applies to both roll and sheet media
*2 To use 2-inch media, the oponal media anges are required. For informaon about oponal items, contact your author-
ized Roland DG Corporaon dealer or visit our website (hp://www.rolanddg.com/).
Maximum Roll Weight
• 64-inch model: 40 kg (88 lb.)
• 54-inch model: 30 kg (66 lb.)
If using the take-up unit, this specicaon depends on the condions of the take-up unit.
Other Condions
Media such as the following cannot be used.
• Media whose end is aached to the paper tube (core)
• Media that is severely warped or that has a strong tendency to reroll
• Media that cannot withstand the heat of the media heang system
• Media whose paper tube (core) is bent or crushed
• Media that bends under its own weight when loaded
• Media on a sagging roll
• Media that is rolled unevenly
About the Media Used
18 1. Basic Information