Roland TrueVIS VG2-540 - Using a Blower-Fan Unit

Using a Blower-fan Unit
This seng is required when using the oponal blower-fan unit. By using a blower-fan unit, you can dry the ink
faster.
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
HEATER MENU
3. Press [▶] once, and then press [▼] several mes to display the screen shown below.
HEATER MENU
BLOWER FAN
4. Press [▶] to display the screen shown below.
BLOWER FAN
DISABLE DISABLE
5. Press [▲] or [▼] to select "ENABLE".
6. Press [ENTER] to conrm your entry.
7. Press [MENU] to go back to the original screen.
MEMO
• Default seng: DISABLE
• For recommended blower-fan unit models, contact your authorized Roland DG Corporaon dealer or visit our website
(hp://www.rolanddg.com/).
• For details on how to use the blower-fan unit, refer to the documentaon of the blower-fan unit you are using.
Adjusting the Ink-drying Method
162 1. Optimizing the Output Quality