Roland TrueVIS VG2-540 - Adjusting the Level of the Sensor for Reading Crop Marks According to the Media

Adjusng the Level of the Sensor for Reading Crop Marks According to the Media
When the sensor for reading crop marks is corrected, the correcon value is stored. When using another media,
adjust the level of the sensor for reading crop marks, as the correcon value may not match.
Procedure
1. Press [MENU].
2. Press [▲] to display the screen shown below.
MENU
CUTTING MENU
3. Press [▶] once, and then press [▼] twice to display the screen shown below.
CUTTING MENU
CROPSENS CALIB.
4. Press [▶], then [▼] to display the screen shown below.
CROPSENS CALIB
SENS LEVEL
5. Press [▶] twice to display the screen shown below.
SENS LEVEL
+20% +20%
6. Press [▲] or [▼] to set the correcon value.
7. Press [ENTER] to conrm your entry.
8. Press [MENU] to go back to the original screen.
Accurately Adjusting the Settings for Cutting with Crop Marks
1. Optimizing the Output Quality 187