Roland TrueVIS VG2-540 - Correcting the Misalignment of the Printing and Cutting Positions During Cutting

Correcng the Misalignment of the Prinng and Cung Posions during Cung
This method pauses a cung operaon to correct the misalignment of the prinng and cung posions. The
correcon values set here are applied as the default values of the prinng and cung posions.
If the prinng and cung posions are misaligned, you normally adjust the posions while checking a test pat-
tern.
P. 169「Correcng the Misalignment of Prinng and Cung」
Procedure
1. During cung, press [PAUSE] to display the screen shown below.
TO CANCEL HOLD
DOWN PAUSE KEY
The cung operaon is paused.
2. Press [FUNCTION].
3. Press [▼] several mes to display the screen shown below.
FUNCTION
CUT CONFIG
4. Press [▶] once, and then press [▼] several mes to display the screen shown below.
CUT CONFIG
PRINT-CUT ADJ.
5. Press [▶].
6. Determine the correcon values.
MEMO
Determine the values so as to correct the misalignment of the cung posion (
) in relaon to the prinng posion ( ). In
the case of the following gure, feed direcon "F" is misaligned in a negave direcon and scan direcon "S" in a posive
direcon. Therefore, set the correcon values for the feed direcon "F" to posive values and the scan direcon "S" to negave
values. Measure the actual misalignment amount when determining the value.
[S]
[F]
7. Set the correcon values for the feed direcon "F" and the scan direcon "S."
(1) Press [▲] or [▼] to set the correcon value for the feed direcon (F).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(2) Press [◀] or [▶] to set the correcon value for the scan direcon (S).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(3) When you have nished seng the correcon values, press [ENTER].
8. Press [PAUSE] to display the screen shown below.
Accurately Adjusting the Settings for Printing and Cutting
172 1. Optimizing the Output Quality