Roland TrueVIS VG2-540 - Page 172

9. Press [▶].
10. Set the correcon values for the feed direcon "F" and the scan direcon "S."
(1) Press [▲] or [▼] to set the correcon value for the feed direcon (F).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(2) Press [◀] or [▶] to set the correcon value for the scan direcon (S).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(3) When you have nished seng the correcon values, press [ENTER].
11. Press [MENU], then [▲] to display the screen shown below.
PRINT-CUT ADJ.
TEST PRINT
12. Press [ENTER].
The test paern (P&C1) is printed and cut. If the prinng and cung lines are aligned, adjustment is com-
plete. If further adjustment is needed, press [▼], then [▶] to go back to step 10 and ne-tune the adjust-
ment.
MEMO
• Default sengs
• F (correcon value of the media feed direcon): 0.00 mm
• S (correcon value of the cung carriage movement direcon): 0.00 mm
Accurately Adjusting the Settings for Printing and Cutting
1. Optimizing the Output Quality 171