Roland TrueVIS VG2-540 - Resetting the Level of the Sensor for Reading Crop Marks

Reseng the Level of the Sensor for Reading Crop Marks
When the sensor for reading crop marks is corrected, the correcon value is stored. When using another media,
reset the level of the sensor for reading crop marks to inial sengs, as the correcon value may not match.
Procedure
1. Press [MENU].
2. Press [▲] to display the screen shown below.
MENU
CUTTING MENU
3. Press [▶] once, and then press [▼] twice to display the screen shown below.
CUTTING MENU
CROPSENS CALIB.
4. Press [▶], then [▼] to display the screen shown below.
CROPSENS CALIB
SENS LEVEL
5. Press [▶], then [▼] to display the screen shown below.
SENS LEVEL
RESET
6. Press [ENTER] to conrm your entry.
7. Press [MENU] to go back to the original screen.
Accurately Adjusting the Settings for Cutting with Crop Marks
188 1. Optimizing the Output Quality