What Is the Media Heang System?
This machine is equipped with a media heang system that warms the media. You use this mainly to improve ink
adhesion and dry the ink. You can adjust the temperature sengs to match the type of media and the prinng
speed.
Dryer This is used to speed up the drying of the ink.
Print heater This heater is used mainly to improve ink adhesion.
WARNING
High temperatures
The platen and dryer become hot. Exercise cauon to avoid burns.
WARNING
When output is not being performed, remove any loaded media or switch o the sub
power.
The connued applicaon of heat at a single locaon may cause the release of toxic gases from the me-
dia or pose a re hazard.
WARNING
Never use media that cannot withstand the heat.
Doing so may result in re or the release of toxic gases or may degrade the media.
WARNING
Never use the dryer for any purpose for which it is not intended, such as to dry clothing.
Doing so may cause overheang, resulng in re or accident.
IMPORTANT
Use the machine in an environment with an ambient temperature of 20 to 32°C (68 to 90°F).
If the machine is used at an ambient temperature lower than 20°C (68°F), then depending on the type or width of the media, wrinkling
or temperature-caused unevenness may occur. If this happens, try lowering the temperature of the media heang system by about 2°C
(36°F). To obtain stable prinng results, however, use the machine in an environment with an ambient temperature of 20 to 32°C (68
to 90°F).
MEMO
By using an auxiliary drying unit, you can speed up the drying of the ink more. For informaon about purchasing an auxiliary drying
unit, contact your authorized Roland DG Corporaon dealer or visit our website (hp://www.rolanddg.com/).
RELATED LINKS
・ P. 161 "Using an Auxiliary Drying Unit"
Adjusting the Ink-drying Method
152 1. Optimizing the Output Quality
To Next Page
Loading...
