Roland TrueVIS VG2-540 - Step 2: Circulating the Ink (Only When Using White Ink)

Step 2: Circulang the Ink (Only When Using White Ink)
This work is not necessary when using eight colors (CMYKLcLmLkOr) or four colors (CMYK). Proceed to step 3.
("Discharging the Wiper Tray Cleaning Liquid").
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
SUB MENU
3. Press [▶] once, and then press [▼] several mes to display the screen shown below.
SUB MENU
INK CONTROL
4. Press [▶] once, and then press [▼] several mes to display the screen shown below.
INK CONTORL
CIRCULATE INK
5. Press [ENTER].
The screen shown below appears, and then the ink circulaon starts. The (approximate) remaining me for
the procedure is displayed on the screen. (The display shown below is an example. "01:45" = "1 minute and
45 seconds")
CIRCULATING INK
>> 01:45
Depending on the ming with which the ink circulaon is started, the following screen may be displayed and
cleaning may start. When cleaning is complete, the ink circulaon will start, so wait for the ink circulaon to
complete. (The display shown below is an example. "01:45" = "1 minute and 45 seconds")
CLEANING...
>> 01:45
When nished, the screen shown below appears again.
INK CONTORL
CIRCULATE INK
Preparing to Move the Machine
308 1. Operations When Moving the Unit