Roland TrueVIS VG2-540 - Using the Correction Functions; Adjust the Misalignment of the Ink Landing Position

To opmize the output quality, it is eecve to use some correcon funcons.
Adjust the misalignment of the ink landing posion.
This adjusts the landing posion of the ink discharged from the print heads. The landing posion varies according
to the print head height and the thickness of the media, so we recommend that you make correcons to match
the media you are using.
First, print a test paern, and then determine and enter the correcon value. Aer entering the correcon value,
print a test paern again and check the correcon results.
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
MEDIA GAP ADJ.
3. Press [▲] or [▶] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
4. Press [ENTER].
Prinng of the test paern starts.
5. When prinng is nished, press [▼], then [▶] to display the screen shown below.
6. View the printed test paern, and then determine the correcon value.
Select the value that gives the least misalignment between the two lines. In the case of the following gure,
select "-3." When you cannot choose between two sequenal numbers, select a value that is between them
(you can set correcon values in units of "0.5").
7. Press [▲] or [▼] to select the correcon value.
8. Press [ENTER] to conrm your entry.
9. Press [◀] or [▲] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
10. Press [ENTER].
Prinng of the test paern starts.
11. Check the test paern to see whether the correcon was successful.
Check that the misalignment is minimized for the two vercal lines indicated by "
" (that is, the current
correcon value). If the misalignment is smaller for another set of vercal lines, set the correcon value
again.
12. When you have successfully performed the correcon, press [MENU] to go back to the original screen.
Using the Correction Functions
1. Optimizing the Output Quality 139