Roland TrueVIS VG2-540 - Correcting the Misalignment of Printing and Cutting with Crop Marks (Concurrent Test for Printing and Cutting with Crop Marks); Correcting the Misalignment of Printing and Cutting with Crop Marks (Concurrent Test for Print- Ing and Cutting with Crop Marks)

Correcng the Misalignment of Prinng and Cung with Crop Marks (Concurrent Test
for Prinng and Cung with Crop Marks)
Depending on the composion of the media, the posioning of prinng and cung may be misaligned even when
you are using crop marks. Make correcons for misaligned prinng and cung for the media you are using.
In cung with crop marks, cung is performed aer removing the media aer prinng. However, with this meth-
od, you can make correcons of prinng and cung posions at the same me without removing the media.
1. Adjust the misalignment of the ink landing posion.
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
MEDIA GAP ADJ.
3. Press [▲] or [▶] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
4. Press [ENTER].
Prinng of the test paern starts.
5. When prinng is nished, press [▼], then [▶] to display the screen shown below.
6. View the printed test paern, and then determine the correcon value.
Select the value that gives the least misalignment between the two lines. In the case of the following gure,
select "-3." When you cannot choose between two sequenal numbers, select a value that is between them
(you can set correcon values in units of "0.5").
7. Press [▲] or [▼] to select the correcon value.
8. Press [ENTER] to conrm your entry.
9.
Press [◀] or [▲] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
10. Press [ENTER].
Prinng of the test paern starts.
11. Check the test paern to see whether the correcon was successful.
Check that the misalignment is minimized for the two vercal lines indicated by " " (that is, the current
correcon value). If the misalignment is smaller for another set of vercal lines, set the correcon value
again.
12. When you have successfully performed the correcon, press [MENU] to go back to the original screen.
Accurately Adjusting the Settings for Cutting with Crop Marks
176 1. Optimizing the Output Quality