Roland TrueVIS VG2-540 - Page 187

2. Check whether crop marks can be read.
Procedure
1. Press [▲] to display the screen shown below.
CROPSENS CALIB
SENS CHECK
2. Press [ENTER] to display the screen shown below.
MOVE CUT TOOL
TO MARK CENTER
3. Press [◀], [▶], [▲] or [▼] to move the center of the blade over the crop marks.
The center of the blade should only be over the crop marks, and does not need to be aligned with the cen-
ter of the crop marks.
4. Press [ENTER].
Check whether crop marks can be read.
If reading succeeds, the following message appears. Proceed to the next step.
CHECK SUCCESS
MARK FOUND
If reading fails, the following message appears.
CHECK FAILED
MARK NOT FOUND
It is possible that crop marks cannot be detected because they are not the crop marks output from the
soware RIP that is compable with this machine. Crop marks drawn using drawing soware also cannot be
detected.
Use the soware RIP that is compable with this machine to output the crop marks and redo the correcon
from the start.
If detecon failed even with crop marks output by the compable soware RIP, redo the correcon from the
sensor correcon stage.
5. Press any one of the keys on the operaon panel to display the screen shown below.
CROPSENS CALIB
SENS CHECK
6. Press [MENU] to go back to the original screen.
Accurately Adjusting the Settings for Cutting with Crop Marks
186 1. Optimizing the Output Quality