Roland TrueVIS VG2-540 - Page 181

2. Print only the crop marks.
Procedure
1. Press [MENU].
2. Press [▲] to display the screen shown below.
MENU
CUTTING MENU
3. Press [▶], then [▼] to display the screen shown below.
CUTTING MENU
CROP-CUT ADJ.
4. Press [▶] twice to display the screen shown below.
TEST PRINT
PRINT ONLY
5. Press [ENTER].
Prinng of the test paern starts.
Only one crop mark is printed.
6. When prinng is nished, press [MENU] to go back to the original screen.
7. Remove any media.
If the media needs to be separated, refer to the following page.
P. 47「Separang the Media」
8. Complete operaons before cung output for normal cung with crop marks, such as laminang.
Accurately Adjusting the Settings for Cutting with Crop Marks
180 1. Optimizing the Output Quality