Roland TrueVIS VG2-540 - Page 182

3. Perform a cung test (separate test for prinng/cung with crop marks).
Procedure
1. Set up the media for which operaons before cung output, such as laminaon, is complete.
2. Press [◀] while the following screen is displayed.
The cung carriage comes out over the platen.
W1100mm
3. Press [◀], [▶], [▲] or [▼] to move the center of the blade over the crop marks.
4. Once the posion has been decided, press [FUNCTION] to display the screen shown below.
FUNCTION
BASE POINT
5. Press [ENTER] to conrm your entry.
When the screen displays the character "B" together with the printable width at the locaon (as shown in
the following gure), seng is completed.
W1100mm
B
6. Press [MENU].
7. Press [▲] to display the screen shown below.
MENU
CUTTING MENU
8. Press [▶], then [▼] to display the screen shown below.
CUTTING MENU
CROP-CUT ADJ.
9. Press [▶] twice, and then press [▼] once to display the screen shown below.
TEST PRINT
CUT ONLY
10. Press [ENTER].
The cung test starts.
Accurately Adjusting the Settings for Cutting with Crop Marks
1. Optimizing the Output Quality 181