Roland TrueVIS VG2-540 - Page 132

MEMO
When you send the output data, "FILLING" or "CLEANING" may be displayed on the screen. These indicate the preparaon
operaons performed before output. Output will begin aer the me displayed on the screen elapses.
IMPORTANT
Output Is Not Possible in These Situaons
• The machine does not run when a cover (front, le, right, or ink slot) is open.
• Data from the computer is not accepted when [SETUP] is dark.
• Prinng does not start unl [HEATER] lights. However, in the following cases prinng is possible even if [HEATER] is not lit.
• The sengs for "PRINT" (print heater) and "DRYER" are "OFF".
P. 153「Seng the Print Heater Temperature」
P. 154「Seng the Dryer Temperature」
• Heater sengs "POWER" is "OFF."
P. 160「Switching O the Print Heater and Dryer Together」
• Data from the computer is not accepted when you are not at the top menu.
Points that must be observed
• Never open a cover (front, le, or right) while output is in progress. Doing so interrupts prinng.
• When you are performing prinng, clamp the edges of the media with the media clamps. Otherwise, the edges of the media
may warp and catch on the print heads.
• During output, do not touch the media. Doing so may obstruct the media feed or cause the media to rub against the print
heads, which may result in a paper jam or damage to the heads.
• Keep the loading lever raised when the machine is not in use.
When not using the machine, remove any media and store it in a suitable environment.
• If the machine is le with the media loaded, the media may be damaged, which may adversely aect prinng. When not
using the machine, remove any media and store it in a suitable environment.
Cutting with Crop Marks
4. How to Cut with Crop Marks 131