Roland TrueVIS VG2-540 - Page 144

CALIBRATION
TEST PRINT
11. Press [ENTER].
Prinng of the test paern starts.
12. Check the test paern to see whether the correcon was successful.
Check that the gap and overlap are the smallest for the gure indicated by "
" (that is, the current correc-
on value). If the gap and overlap are smaller for another gure, set the correcon value again.
13.
When you have successfully performed the correcon, press [MENU] to go back to the original screen.
MEMO
Depending on the soware RIP you are using, you can also congure this seng in the soware RIP (by, for example, choosing
the media type). When you have made the seng in the soware RIP, the soware RIP's seng is used and the printer's
seng is ignored.
Using the Correction Functions
1. Optimizing the Output Quality 143