Roland TrueVIS VG2-540 - Page 165

Display screen (cung condions) Seng details
Default set-
tings
CUT CONFIG
FORCE
Set the force (pressure) of the blade.
50 gf
CUT CONFIG
SPEED
Set the speed of cung.
30 cm/s
CUT CONFIG
OFFSET
Set the blade oset. Enter the listed oset value for the blade.
The oset value for the included blade is 0.250 mm (9.8 mil).
0.250mm
CUT CONFIG
UP-SPEED
Set the blade's up speed during cung (the speed at which the blade
travels when it moves to the next cung line aer cung one cung
line). If the media comes loose during no-load feed and the blade
damages the surface of the media, reduce the speed.
30 cm/s
10. Press [▶] to display the screen shown below.
FORCE
50gf 50gf
SPEED
30 cm/s 30 cm/s
OFFSET
0.250mm 0.250mm
UP-SPEED
20 cm/s 20 cm/s
11. Press [▲] or [▼] to select a value.
12. Press [ENTER] to conrm your entry.
13. Press [◀] to go back to step 9.
Repeat steps 9 and 10 to adjust the cung condions.
14. Press [FUNCTION] to go back to the original screen.
Accurately Adjusting the Cutting Settings
164 1. Optimizing the Output Quality