Roland TrueVIS VG2-540 - Page 192

Menu item Reference page
[DRYING TIME]
P. 158「Seng the Drying Time aer Prinng (When On-
ly Prinng)」
[DRY TIME P&C]
P. 159「Seng the Drying Time aer Prinng (When
Prinng and Cung)」
[MEDIA GAP ADJ. SIMPLE SETTING]
P. 139「Adjust the misalignment of the ink landing posi-
on.」
[MEDIA GAP ADJ. DETAIL SETTING]
P. 140「Accurately Adjusng the Misalignment of the Ink
Landing Posion」
[CALIBRATION]
P. 142「Reducing Horizontal Bands (Feed Correcon
Funcon)」
[EDGE DETECTION]
P. 146「Using Transparent Media」
[SCAN INTERVAL]
P. 147「Using Hard-to-Dry Media」
[VACUUM POWER]
P. 148「Using Media That Wrinkles Easily/Does Not
Move Smoothly」
[FULL WIDTH S]
P. 195「Speeding Up Output for Narrow Media」
[MEDIA RELEASE]
P. 149「Using Scky Media」
[FORCE], [SPEED], [OFFSET], [UP-SPEED]
P. 163「Fine-tuning the Cung Condions」
[CALIBRATION] (in the [CUTTING MENU])
P. 166「Performing Distance Correcon during Cung」
[PRINT-CUT ADJ.]
P. 169「Correcng the Misalignment of Prinng and Cut-
ting」
[CROP-CUT ADJ.]
P. 176「Correcng the Misalignment of Prinng and Cut-
ting with Crop Marks (Concurrent Test for Prinng and Cut-
ting with Crop Marks)」
P. 179「Correcng the Misalignment of Prinng and Cut-
ting with Crop Marks (Separate Test for Prinng/Cung with
Crop Marks)」
[CROP SENSOR ADJ.]
P. 187「Adjusng the Level of the Sensor for Reading
Crop Marks According to the Media」
Using Presets
2. Optimizing Work Efficiency 191