Roland TrueVIS VG2-540 - Page 233

MEDIUM CL.
A
(3) Repeat steps 1 and 2 to display only the group of print heads that requires cleaning.
Only the displayed groups will be cleaned. If A and B are displayed, they will both be cleaned.
9. Press [ENTER] to conrm your entry.
The screen shown below appears, and then cleaning starts. The (approximate) remaining me for the proce-
dure is displayed on the screen. (The display shown below is an example. "01:45" = "1 minute and 45 sec-
onds")
CLEANING...
>> 01:45
When nished, the screen shown below appears again.
MEDIUM CL.
AB
10. Press [◀] once, and then press [▼] several mes to display the screen shown below.
CLEANING
TEST PRINT
11. Press [ENTER].
Perform a prinng test again to check whether the dot drop-out and dot displacement have been corrected.
MEMO
• If the problem persists, try performing medium cleaning again.
• If problems such as dot drop-out and dot displacement persist even aer you have performed medium cleaning several
mes, perform "powerful cleaning."
P. 233「Powerful Cleaning Method」
• This cleaning can be eecve when carried out periodically, according to the frequency of use.
When Normal Cleaning Is Not Effective
232 2. Regular maintenance