Roland TrueVIS VG2-540 - Page 258

Preparaon is complete once the following screen is displayed.
FINISHED?
IMPORTANT
Do not press the [ENTER] key at this stage. Press [ENTER] aer replacing the wipers and the tray pads. If you press [ENTER] at
this stage, close the right cover according to the instrucons on the screen, wait for the following screen to be displayed, and
then press [ENTER] again.
MAINTENANCE
REPLACE WIPER
9. Touch the locaon shown in the gure to discharge any stac electricity.
10. Replace the wipers.
(1) Detach the old wipers.
Using the tweezers, unhook the wipers, and then pull them up. Using the tweezers to press on the
hook in the hole on the wiper makes it easier to remove the wiper.
(2) Aach the new wipers.
Place the inclined end of the wiper on the back side of the machine. If the wiper is installed with the
incorrect orientaon, appropriate cleaning will not be possible.
Be sure to aach the wipers to the hooks. Failure to do so may result in dot drop-out or other prob-
lems.
Replacing Parts for Maintenance
4. Replacing Consumable Parts 257