Roland TrueVIS VG2-540 - Page 264

9. Replace the blade.
(1) Press the pin (A) to push out the old blade (B).
(2) Insert a new blade (C).
Orient the p of the blade (D) correctly.
A
B
C
D
10. Install the cung tool in the cung carriage.
OK Not OK
11. Tighten the screw.
Tug the blade holder upward to make sure it does not come loose.
12. Close the front cover.
13. Press [ENTER].
When the following screen is displayed again, the blade replacement is nished.
Replacing the Blade/Separating Knife
4. Replacing Consumable Parts 263