Roland TrueVIS VG2-540 - Page 266

2. Make adjustments according to the new blade.
Procedure
1. Close the front cover.
2. Press [◀], [▶], [▲], or [▼] to move the cung carriage to the locaon where you want to carry out the cung test.
You can freely set the locaon for the cung test.
3. Press [FUNCTION].
4. Press [▼] several mes to display the screen shown below.
FUNCTION
CUT CONFIG
5. Press [▶] to display the screen shown below.
CUT CONFIG
TEST CUT
6. Press [ENTER].
The test paern is cut.
7. When the cung of the test paern is nished, press [▼].
8. Check the results of the cung test.
Check item
Result Seng item Adjustment
Check the shape. The cut shape is distorted. SPEED Reduce
Peel o the circle.
The square also peels o. FORCE Increase
Some uncut areas remain. SPEED Reduce
Peel o the square.
The blade leaves faint traces on the backing paper.
FORCE
No change
The blade trace is indisnct. Increase
The blade trace is too deep and cuts into the back-
ing paper.
Reduce
Check the shape of the
square you have peeled
o.
The corners are not rounded and
do not have "horns."
Oset
No change
The corners are rounded. Increase
The corners have "horns." Reduce
9. Press [▲] or [▼] to select the cung condion you want to set.
Replacing the Blade/Separating Knife
4. Replacing Consumable Parts 265