3. Pass the leading edge of the media between the pinch rollers ( ) and the grit rollers ( ).
4. Lower the loading lever (rear).
The media is held in place.
At this me, the message "PRESS ENTER KEY TO SETUP" is displayed on the screen, but do not press the
[ENTER] yet, and proceed to the next step.
5. (Move to the front of the printer.) Gently hold down the media and raise the loading lever (front).
The media is released.
6. Pull out the media over the apron.
Setup of Media
34 2. Basic Operations
To Next Page
Loading...
