Roland TrueVIS VG2-540 - Page 4

Accurately Adjusng the Sengs for Cung with Crop Marks................................................................................................. 174
Aligning the Posions of Cung with Crop Marks Manually ........................................................................................... 174
Correcng the Misalignment of Prinng and Cung with Crop Marks (Concurrent Test for Prinng and Cung with Crop
Marks) ..................................................................................................................................................................... 176
Correcng the Misalignment of Prinng and Cung with Crop Marks (Separate Test for Prinng/Cung with Crop
Marks) ..................................................................................................................................................................... 179
Correct the sensor for reading crop marks....................................................................................................................... 184
Adjusng the Level of the Sensor for Reading Crop Marks According to the Media........................................................ 187
Reseng the Level of the Sensor for Reading Crop Marks .............................................................................................. 188
2. Opmizing Work Eciency................................................................................................................................. 189
Using Presets ............................................................................................................................................................................. 190
Saving the Current Sengs in Presets.............................................................................................................................. 190
Loading and Outpung a Preset...................................................................................................................................... 192
Adjusng the Output-start Locaon.......................................................................................................................................... 193
Seng the Base Point ...................................................................................................................................................... 193
Reducing Output Time............................................................................................................................................................... 195
Speeding Up Output for Narrow Media ........................................................................................................................... 195
Using the Media Take-up Unit ................................................................................................................................................... 196
About the Media Take-Up Unit......................................................................................................................................... 196
Performing Operaons from the Dedicated Mobile Operaon Applicaon.............................................................................. 197
What Is the Dedicated Mobile Operaon Applicaon?.................................................................................................... 197
Downloading the Operaon Applicaon.......................................................................................................................... 198
Using the Operaon Applicaon ...................................................................................................................................... 199
Important Notes on Using the Operaon Applicaon ..................................................................................................... 200
Other Useful Funcons.............................................................................................................................................................. 202
Using the Print Light (Interior Light)................................................................................................................................. 202
Performing Prinng Tests Arranged Horizontally ............................................................................................................. 203
Using Media Flanges for Paper Tubes (Cores) with an Internal Diameter of 2 Inches...................................................... 204
3. Opmizing Operaon Management................................................................................................................... 205
Managing the Operaons Appropriately and Eciently ........................................................................................................... 206
Seng the Current Date/Time and Using It for Maintenance ......................................................................................... 206
Displaying the Amount of Media Remaining.................................................................................................................... 207
Making Sure to Verify the Seng for the Amount Remaining Every Time the Media Is Changed................................... 208
Prinng the Amount of Remaining Media........................................................................................................................ 209
Thoroughly Using the Middle Pinch Rollers...................................................................................................................... 210
Seng the Acvaon Interval for Sleep Mode (Power-saving Feature)........................................................................... 211
Managing the Basic Sengs of the Printer ............................................................................................................................... 212
Seng the Menu Language and Units of Measurement ................................................................................................. 212
Turning on Bluetooth Communicaon ............................................................................................................................. 213
Viewing System Informaon ............................................................................................................................................ 214
Returning All Sengs to Factory Defaults ........................................................................................................................ 215
Chapter 4 Maintenance ..............................................................................................................216
1. Introducon........................................................................................................................................................ 217
Important Notes on Handling and Use ...................................................................................................................................... 218
Printer .............................................................................................................................................................................. 218
Ink Pouches ...................................................................................................................................................................... 219
Basic Maintenance Knowledge.................................................................................................................................................. 220
Types and Timing of Maintenance ................................................................................................................................... 220
Measures When the Printer Is Not in Use for a Prolonged Period................................................................................... 221
2. Regular maintenance.......................................................................................................................................... 222
Cleaning the Machine................................................................................................................................................................ 223
Cleaning the Media Path .................................................................................................................................................. 223
Cleaning the Knife Carriage Roller .................................................................................................................................... 224
Contents
3