Roland TrueVIS VG2-540 - Page 40

MEMO
Press down on the bent part of the media clamps to li up both of their edges. Move the media clamps to the le and right
with both edges lied up.
7. Close the front cover.
The "PRESS ENTER TO PERFORM SETUP" message is displayed on the screen.
8. Press [ENTER].
When you press [ENTER], the cung carriage moves and detects the width of the media. This operaon is
called inializaon. When inializaon ends, [SETUP] on the operaon panel lights, and the printable width
is displayed on the screen. This completes the setup of the media.
IMPORTANT
Remove when not using roll media.
Do not leave roll media loaded on the machine for a long period of me. Be sure to remove and store the media when not in
use. Leaving the roll media loaded on the machine for a long period of me will cause the media to sag, which may deteriorate
the prinng quality and may also lead to motor errors.
Setup of Media
2. Basic Operations 39