2. Finish setup (sheet media).
Procedure
1. Make sure both edges of the media are above the grit rollers.
Be sure to place the right edge of the media on the right-end grit roller.
2. Move the le and right pinch rollers, placing them on both edges of the media.
Posion them approximately 10 mm (0.39 in.) from each edge of the media.
Point
• Be sure to use the le and right pinch rollers. The force with which the media is pinched varies between the middle pinch
rollers and the le and right pinch rollers. Using the middle pinch rollers to pinch the media will lead to unstable media
feeding.
• To move the pinch rollers, push down close to the rail.
3. Move the middle pinch rollers ( ) over all the remaining grit rollers covered by the media ( ).
There are grit paerns (3) wherever there are grit rollers.
Setup of Media
2. Basic Operations 43
To Next Page
Loading...
