Roland TrueVIS VG2-540 - Page 50

8. Set the correcon values from "H1" to "H4."
(1) Press [◀] or [▶] to select a value from H1 to H4.
(2) Press [▲] or [▼] to select the correcon value.
H4
0
H1 H2 H3
0 0 0
(3) When you have nished seng the correcon values, press [ENTER].
The screen shown below appears again.
DETAIL SETTING
SETTING NO.1
9. Press [▼] to display the screen shown below.
DETAIL SETTING
SETTING NO.2
10. 8. Set the correcon values from "MEDIA GAP ADJ. NO.2 H1" to "MEDIA GAP ADJ. NO.2 H4" in the same manner as
step.
11. Press [▼] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
12. Press [ENTER].
Prinng of the test paern starts.
13. Check the test paern to see whether the correcon was successful.
For all the correcon values, check that the misalignment is minimized for the two vercal lines indicated by
"
" (that is, the current correcon value). If the misalignment is smaller for another set of vercal lines, set
the correcon value again.
14. When you have successfully performed the correcon, press [MENU] to go back to the original screen.
What to Do First after Installation
2. Basic Operations 49