Roland TrueVIS VG2-540 - Page 64

2. Performing Normal Cleaning
Procedure
1. Press [FUNCTION] to display the screen shown below.
FUNCTION
BASE POINT
2. Press [▼], then [▶][▼] to display the screen shown below.
CLEANING
NORMAL CL.
3. Check for the group with dot drop-out or dot displacement by viewing the results of the prinng test.
The space from "A" to "B" is group A. The space from "B" to the right side is group B.
MEMO
If the prinng-test results are dicult to interpret
Check the results in a bright locaon, changing your line of vision. It is visible using the reecon of the light.
4. Press [▶].
5. Select the group of print heads to clean.
(1) Press [◀] or [▶] to select the group of print heads that is not to be cleaned.
NORMAL CL.
AB
(2) Press [▲] or [▼] to get rid of the group display.
NORMAL CL.
A
(3) Repeat steps 1 and 2 to display only the group of print heads that requires cleaning.
Only the displayed groups will be cleaned. If A and B are displayed, they will both be cleaned.
6. Press [ENTER] to conrm your entry.
The screen shown below appears, and then cleaning starts. The (approximate) remaining me for the proce-
dure is displayed on the screen. (The display shown below is an example. "01:45" = "1 minute and 45 sec-
onds")
CLEANING...
>> 01:45
When nished, the screen shown below appears again.
Preparations before Printing Output
1. Printing Method 63