Roland TrueVIS VG2-540 - Page 69

4. Perform posion adjustment of the feed direcon (reduce horizontal stripes).
Feed direcon means the feed direcon of the media. Perform the correcon adjusng to the media in advance
because horizontal strips are more likely to occur during prinng when the movement distance of the media
changes subtly depending on the media’s thickness.
Procedure
1. Press [◀] to select "SET".
CALIBRATION
[SET] NEXT
2. Press [ENTER] to conrm your entry.
Prinng of the test paern starts.
You can select "NEXT" and press [ENTER] to skip the current menu and proceed to the next menu.
3. Press [ENTER].
INPUT
ADJ. VALUES
4. View the printed test paern, and then determine the correcon value.
= Current correcon value ( ) Select the value to make the gap ( ) and overlap ( ) between the up-
per/lower squares smallest. In the case of the following gure, select "-0.40." When you cannot choose be-
tween two sequenal numbers, specify a value that is between them.
5. Press [▲] or [▼] to select the correcon value.
CALIBRATION
0.00% +0.05%
6. Press [ENTER] to conrm your entry.
7. Press [◀] to select "SET".
REDO ADJ.?
[YES] DONE
8. Press [ENTER] to conrm your entry.
The test paern is printed again. Check that the gap and overlap are the smallest for the gure indicated by
" " (that is, the current correcon value). If the gap and overlap are smaller for another gure, return to
step 5 to perform the seng again.
If you do not need to change the correcon value, press [ENTER] again.
9. Press [▶] to select "DONE".
Printing Output
68 1. Printing Method