Roland TrueVIS VG2-540 - Page 72

6. Set the drying method and me aer prinng.
Procedure
1. Press [◀] or [▶] to select "NEXT".
CUT CONFIG
SET [NEXT]
2. Press [ENTER] to conrm your entry.
FEED FOR DRY
DISABLE ENABLE
3. Press [▲] or [▼] to select "ENABLE" or "DISABLE".
Set whether the media should be fed unl the trailing edge of the printed area is put on the dryer aer the
1st page is printed. To make sure to dry the enre printed area, select "ENABLE". If "DISABLE" is selected,
the trailing edge of the prinng area is not fed to the dryer unless you connue with a subsequent prinng
operaon.
FEED FOR DRY
DISABLE ENABLE
4. Press [ENTER] to conrm your entry.
5. Press [▲] or [▼] to set the drying me.
Set the drying me aer the 1st page is printed. The next operaon is not started unl the set me passes.
DRYING TIME
10min 10min
MEMO
This seng is enabled for output data designed only for prinng.
This seng is ignored for output data designed for prinng and cung. When the drying me has been set in the soware RIP,
priority is given to the soware RIP's seng.
Example of seng me (general guide)
The seng me varies according to the sengs such as the type of media and the prinng quality.
• Condion Non-coated vinyl chloride media
• Seng me: About three minutes
6. Press [ENTER] to conrm your entry.
7. Press [ENTER] when the following screen appears.
DRY TIME P&C
10min 10min
This seng is ignored for output data designed only for prinng. Any value is acceptable, so press [ENTER]
and proceed to the next step.
Printing Output
1. Printing Method 71