Roland TrueVIS VG2-540 - Page 95

Reduce the blade force.
12. Press [ENTER] to conrm your entry.
13. Press [▲] to display the screen shown below.
CUT CONFIG
TEST CUT
14. Press [ENTER].
The test paern is cut.
15. Check whether the correcon was successful.
At the [CUT CONFIG] menu, you can also make sengs for other cung condions in addion to the blade force.
Refer to the following page.
RELATED LINKS
・ P. 163 "Fine-tuning the Cung Condions"
Preparations before Printing and Cutting Output
94 3. Printing and Cutting Method