Roland TrueVIS VG2-540 - Page 98

3. Adjust the print head height.
Procedure
1. Press [◀] to select "CHANGE."
HEAD HGT LOW
[CHANGE] NEXT
2. Press [ENTER] to conrm your entry.
You can select "NEXT" and press [ENTER] to skip the current menu and proceed to the next menu.
3. When the following screen is displayed, open the front cover.
HEAD HEIGHT
LOW LOW
4. Move the height-adjustment lever to adjust the head height.
When you change the posion of the height-adjustment lever, the display screen changes and the buzzer
sounds at the same me.
Posion Display Screen
HIGH
HEAD HEIGHT
LOW HIGH
MIDDLE
HEAD HEIGHT
LOW MIDDLE
LOW
HEAD HEIGHT
LOW LOW
MEMO
• Normally move the height-adjustment lever to "LOW." For media that is wrinkled or comes loose from the platen, move the
height-adjustment lever to "MEDIUM" or "HIGH."
• The prinng quality degrades as the distance between the media and the print heads increases. Do not move the height-
adjustment lever to "MEDIUM" or "HIGH" needlessly.
5. Close the front cover.
Printing and Cutting Output
3. Printing and Cutting Method 97