SatLab SLT2 - Page 137

Total Station Manual
-
136
-
③ In [Stakeout Grid] interface,
use [
◄
]\[
►
] to select the offset,
chainage, then press [F1](ALL) or
[F2]+[F3] (DIST+REC) to save this
measuring point data.
[◄]\[►]
+
[F1]
or
[F2]+[F3]
※ In above operations, press [ESC] to return to previous menu.
 Measure Line&Offset
Steps
Key
Display
① In interface of [Reference
Line-Main] , press [F2] (Meas.)
to enter [Measure Line&Offset]
interface.
[F2]
○
2
There are many methods to
obtain points for calculating
Line&Offset
A: Input the name of point,
press [F1](ALL) to measure
current point, calculate and
display the offset to refline ,
then save this point data.
Input point
name
+
[F1]
A: Get the target point by
measure.
B: Input point name, press [F2]
(DIST) to measure target point,
calculate and display this point's
offset to refline, then press
[F3](REC) to save this point data.
[F2]
+
[F3]
B: Get the target point by
DIST+REC.