SATO s84ex - Page 339

331
5) Item No. check function
The printer will check the item No. in the print data if it is incremented one by one with every item. If it is not, the printer will
arise "item No. error" at the print start of the item and stop the printing.
The LCD display of the item No. error
There are 4 ways to release the item No. error.
(1) Press the LINE key
The printer will resume the printing from the print data with the item No. error.
(2) Send SUB command
The printer will resume the printing after releasing the error.
Upon reception of this command, it is possible to select if you want to print or cancel
the data with the error.
(3) Send CAN command
The printer will cancel the print data with the error and resume the printing from the
next print data.
(4) Press the CANCEL key
The printer will cancel the print data with the error and resume the printing from the
next print data.
The history data with the item No. error will be processed as follows according to the error cause.
(1) When the item No. is not
specified or the digit is not
correct
The item No. will be "*****" and status No. 03 "item No. error" will be recorded.
(2) When the item No. is not
incremented by 1
The specified item No. and status No. 03 "item No. error" will be recorded.
[Supplemental explanation]
1. The item No. check is targeted only for the print data. Data without printing such as registration data or printer setting
commands are not targeted. With those data, please specify "*****" as the item No.
2. When the item No. is specified by the starting item No. specifying command <IQ>, the starting item No. of the next
data will be the item No. specified by <IQ> + 1.
ITEM NO ERROR
*The item No. error will be detected only when the item No. check is enabled.