What to do if my SATO Label Maker shows an 'Overheat error'?
If your SATO Label Maker is overheating, it means the printer's temperature has exceeded its tolerance. Stop using the printer and allow it to cool down.
What to do if my SATO Label Maker displays a 'Cover open error'?
If your SATO Label Maker shows a 'Cover open error', it means the cover is opened or the sensor for sensing the open/close status of the cover is defective. Ensure the cover is securely closed. If the error continues, the sensor may need replacement.
What to do if my SATO Label Maker shows a 'Head open' error?
If your SATO Label Maker shows a 'Head open' error, it means the print head is unlocked or the sensor for sensing the open/close status of the print head is defective. Make sure the print head is locked. If the problem persists, the sensor may need to be replaced.
What to do if my SATO s84ex Label Maker displays a 'Ribbon end' error?
If your SATO Label Maker displays a 'Ribbon End' error, it could be due to several reasons: the ribbon is not loaded, damaged, or not loaded correctly, or the ribbon is torn. To resolve this, load a new ribbon correctly. If the ribbon is torn, clean and adjust the ribbon path.
What to do if my SATO s84ex Label Maker shows a 'Paper end' error?
If your SATO Label Maker displays a 'Paper End' error, it means the media is either not loaded, not loaded correctly, has jammed, or the media sensor is dirty or has a disconnected cable. First, load the media correctly and remove any jammed media. Then, clean the media sensor and ensure its cable is correctly connected. You may also need to adjust the sensor level.
Why am I getting a download data error on my SATO Label Maker?
A download data error on your SATO Label Maker can occur if the downloaded data is incorrect or if the download area is insufficient. Check the downloaded data and the downloaded data size.
General| Max Print Length | 39.37 inches |
|---|---|
| Print Method | Thermal Transfer / Direct Thermal |
| Connectivity | USB, Serial |
| Supported Barcode Types | Data Matrix, PDF417, QR Code |
| Supported Media Types | Roll, Fanfold |
| Media Thickness | 0.002 to 0.008 inches |
| Operating Temperature | 41 to 95°F (5 to 35°C) |
| Dimensions | 18.11" D x 12.6" H |
| Print Width | 4.09 inches |
| Max Print Width | 4.09 inches |
| Memory | 16MB Flash, 32MB SDRAM |
To Next Page
