SBC PCD1 Series User Manual

Saia-Burgess Controls AG
Manual Manual PCD 1 / PCD 2 Series │ Document 26 / 737 EN22 │ 2013-11-26
CPUs and expansion housings
3-63
InternalLEDdisplaysandsmallterminals
3
3.20.4 PCD7.D16x Small terminal kits
ThePCD1andPCD2CPUscanbettedwithasmallterminal,mountedinthecover:
There are 4 × 16 characters available, and the dialogue can be conveniently created
intheHMIEditor.TheHMIEditorisanintegralpartofthePG5software.
The terminal communicates with the CPU via a communication module, which occu-
pies socket B or B1. The following variants are available:
Kit Communication module,
additional interfaces
Suitable for
PCD7.D162 PCD2.F540
1)
No additional interfaces; the terminal
occupies Port 2
PCD1.M1xx
PCD2.Mxx0
PCD7.D163 PCD2.F550
1)
One additional RS-485 / RS-422
interface (occupies Port 3
2)
), the terminal
occupies Port 2
PCD2.M120/M150/M170/M480
PCD7.D164 PCD7.F774
1)
Probus DP Slave
3)
and an additional
RS-485 / RS-422 interface (occupies Port
3
2)
); the terminal occupies Port 2
PCD1.M13x
PCD2.M120/M150/M170
PCD7.D165 PCD7.F804
1)
LON interface
4)
and an additional
RS-485 / RS-422 interface
(occupies Port 3
2)
); the terminal occupies
Port 2
PCD1.M13x
PCD2.M120/M150/M170
1) Only obtainable as part of the PCD7.D16x kit
2) The connection is identical to Port 3 on a PCD2.F520; please refer to section 4 for more details
3) For Profibus DP, minimum hardware and firmware versions are required; please refer to the Profibus DP manual
26/765
4) ForLON,minimumhardwareandfirmwareversionsarerequired;pleaserefertotheLONmanual26/767
WerecommendorderingthePCD7.D16xkitsmountedontheCPUs.Mountinglaterispos-
sible, but requires:
PCD1: replacing the cover, item-no. 4 104 7338 0
PCD2: removing the red viewing window and drilling 4 mounting holes; the position of the
holes can be seen on the inside of the cover

SBC PCD1 Series Specifications

General

Brand	SBC
Model	PCD1 Series
Category	Controller
Language	English